Published on
Image description
As April wound down, we visited with family and friends and got back into the routine in Hampton, swimming regularly at the Community Center. But the BIG news is that Orion's engine is re-installed and runs beautifully. 

Image description
Have Engine, Will Travel

After waiting out some bad weather days, we were more than ready when Bill, our engine mechanic, said he was coming on Saturday to re-install Orion's engine. To re-cap the story; we discovered a problem with the engine last summer, requiring it to be re-built. We had it pulled out and re-built over the winter, fixing the damaged #1 cylinder and anything else Bill noticed that needed attention. In anticipation of its arrival, we had sanded and painted the motor mounts, checked and replaced the starting battery and cleaned the engine room floor.  

Image description
Bill arrived Saturday morning with the re-built engine, a bucket of tools, a dolly and 3 strapping young men to help wrestle the engine from truck to dock to boat. When removing the engine last fall, we had been able to take several heavier pieces off and remove them separately, making the core engine lighter. This would not be the case with the re-install. All of the components were installed and would stay that way, making the engine much heavier. So, after using the dolly to cart it down the dock to the finger pier, the heavy lifting (literally) was about to begin. Bill placed a board across Orion's cockpit and the 4 lifted the engine onto the board from the dock. (Luckily the tide wasn't too high at this point.) They then slid the engine forward toward the companionway and positioned it under the boom, which had a “come-along” suspended from it. Using a chain to secure the engine to the come-along, Bill lifted it off the deck and lowered it into the companionway, while one of his sons guided it to the floor level and into the enjgine room. Despite the tight confines of the engine room, Bill managed to crawl in to position himself on the engine's starboard side. With one son at the aft end and one at the forward end, the three men used a 2 x 4 through the chain around the engine to lift it onto the motor mounts.  

Image description
With the engine in place, it needed to be aligned and then re-attached to all the systems: fuel, fresh water, raw water, batteries, ignition, sensors, throttle, etc.

The alignment process was quick, with only minor adjustments required to re-connect the drive shaft. One by one, the hoses, bolts and wires were re-attached. We opened the raw water through-hulls and were ready for the moment of truth. With Dave on deck and Cathy and Bill down below, we started her up and the sound was music to our ears. After a few minutes, Dave put the engine into gear. There was some knocking that didn't sound too good as it moved into gear. We discussed the idle rpm's and decided they were too low. Bill increased the idle a bit and the sound disappeared. The engine moved from neutral into forward and reverse and ran at higher rpm's effortlessly. Orion is finally whole again.

You might think that we immediately dropped the lines and headed out for a sea trial. However, there was more to it than that. Orion's hull had not been thoroughly cleaned since September. So, before moving her out of the slip, we needed a diver to clean the bottom. It didn't make sense to do that right away, since we were about to leave her for a week or two. As we were loading our engine on board, Pat and Fred were making their way up through NC toward us, and arrived in Hampton a couple of days later. We were planning to take Pat's place and help Fred move Marianna the rest of the way home. So, it didn't make sense to have someone clean the hull, when the boat would then sit for another couple of weeks, getting fouled again. The sea trial would just have to wait until we got back.

Battery Ups and Downs

While in Marathon, we received a call from our friend, Steve, about a problem with Orion. It appeared the inverter had somehow been turned on and left running, and since she was disconnected from shore power, this had drained the batteries. Just in case there was something wrong with the inverter, Dave talked Steve through disconnecting it from the battteries and then had him plug the boat into shore power. After a few days, he called back to say the battery monitor continued to show very low voltage on the house bank. So, as we returned to Otion, Dave was sure he was looking at some serious battery problems and likely some replacements

As he began to check each battery in the house bank and its voltage, he was becoming confused. Although the battery monitor continued to show seriously low battery voltage, what he measured on the batteries themselves was much higher and well within normal range for the 12V battery. The Xantrex Link 20 had been working well for a long time, so we had come to trust the numbers it gave, but it was time to investigate further. We discovered an error message on the display that we learned was due to an “open lead” on the wire that sensed the battery voltage on one of the battery banks. After eliminating any corrosion in the connections on either end as a possible cause, we managed to find a gap in the insulation a few feet from the batteries that was the source of the problem. Dave cut the wire at the break and spliced the wires together. No more low voltage. The house batteries were fine. 

It also appeared that there was no problem with the inverter, which Dave simply re-connected.

However, the starting battery was another story. The sulphur smell coming from it once we re-connected to shore power made it plain that it had a problem. Upon closer inspection, Dave discovered the cap had popped off the top. So, we replaced it with a new Group 24 and it started the engine without a hitch.
Image description
Blessings

We were lucky enough to join the grandkids to celebrate our oldest grandaughter's, Alexis' birthday at a roller skating rink in Richmond. Since most of the kids were only on skates for the first or 2nd time. It was helpful to have a couple more adults to help the little ones around the rink. It was fun, and pretty amazing that the neither of us big kids ended up on the floor in the process. 
Picture

Adam skates with Jayden and Troy

Image description



On the following weekend, just after our engine was installed, we attended our first event at the Old Point Comfort Yacht Club, which we had joined in the fall. (Our first event was supposed to have been the night before Sandy arrived.) We attended the Blessing of the Fleet, joining Sue and her friend Steve on Steve's power boat, Pla-Sea-Bo. Earlier that week, we had received a panicked call from Sue that she was taking on water on Daisy Sue. Dave had responded and helped her locate the source of the problem within the toilet's vented loop, complicated bya non-working bilge pump. Luckily, this problem was discovered before Sue headed out up the bay to have her boat hauled. So, although Orion and Daisy Sue were not able to be blessed directly, they got a much-needed blessing by proxy by virture of our presence on Pla-Sea-Bo. After being properly blessed, we joined the club for lunch. Later, we took a tour of Norfolk on Pla-Sea-Bo, before returning home late that evening.

Pat and Fred arrived at Joy's on Monday, having struggled north after suffering a lightning strike off Dinner Key in early April. After securing Marianna to the slip next to Orion, we caught up on the weeks since we'd seen them. Dave helped Fred rig a fuel pump to help him clean the fuel in one of his tanks, while Cathy arranged to have supper on Orion. By Wednesday, they were on their way north to deliver Pat and a car full of Marianna's excess baggage to New Hampshire. When Fred returned, we would join him for the trip further north.  

Published on
Image description
After making our way north from Naples to Fort Myers Beach, we turned into the Okeechobee Waterway toward Florida’s inland.  For the 2nd year in a row, we left Orion Jr in a slip in Labelle, FL as we headed north to her bigger cousin in Hampton.  With Sue’s help, we made much shorter work of prepping Jr for summer storage.

 


Image description
A Final Sail and then the Okeechobee Waterway

With a large front scheduled to arrive on Friday, we decided to head out of Naples on Wednesday for Fort Myers Beach, where we would weather the storm.  The winds were supposed to be light from the southeast, which is why it should have been no surprise that we were surfing into Fort Myers Beach on strong southwesterlies.  We put the sails to good use on the trip, furling them only as the boat traffic increased as we approached the channel near the trip’s end. 

After a couple of days and some weather had passed, we were debating when to leave for Franklin Lock, our first stop on the Okeechobee Waterway.  We had a lot to do, most of which couldn’t start until we got to a dock at the Corps of Engineers’ park just past the first of the waterway’s locks.  So, on Saturday, after checking out the winds by walking to the beach and the island’s eastern point, we decided to drop the mooring and head out around noon.  We hoped to make it through the lock before it closed at 7pm, which we managed to do, pulling alongside the locks wall’s just after 6:30.  Once clear, we dropped anchor in the basin east of the lock.  

Image description
The slips were all full, but we had one reserved for the following night.  Our plan was to pull into our slip or the first one that opened up in the morning.  By 8:30am, we were pulling anchor and made a quick hop into the slip.  At that point, a flurry of activity started that didn’t end until sunset.  We washed everything – sails, bimini, enclosure, deck, cushion covers, life jackets, etc.  We emptied the solids from the head and scrubbed it clean as well.  We dropped and flaked the sails, cleaned the dinghy inside and out.  We removed the solar panels, scrubbed them and then once the bimini was clean and dry, Cathy waterproofed it.  She next protected the enclosure glass with strataglass cleaner. 

With everything clean on deck, we switched to other preparations.  Sue put reflective insulation over the inside and outside of the portlights, after we made one more attempt to seal the leaking portlight with silicone.  After cleaning the anchor chain, Dave switched it end to end to extend its life and re-marked the lengths with paint.  With access to power, we had plugged in as soon as we arrived in hopes that the batteries would be fully charged before we left and maybe even equalize.  

Image description
Since Monday’s trip to  LaBelle would be a short one, we took a little more time on the dock, since the batteries did manage to equalize.  Hooray!  The wind picked up as made our way east.  By the time we made it past Labelle’s bridge, we were strategizing how to make the little boat back into the slip.  With a couple of tries and some not so pretty maneuvers, we were in the slip, ready to begin the 2nd round of boat prep just after lunch.

While Dave and Sue rigged Jr in the slip – stringing 16 lines to the various pilings, Cathy cleaned below.  We had little staging area, so until we picked up the car the next day, packing things up would have to wait.  On Tuesday, this began in earnest, so that by the time Dave returned with the car, we had many piles of stuff ready to be loaded.  By now, we could start stripping the deck in earnest, the anchors, the stackpack, the enclosure, the outboard.  When we got the last of the water we needed, we hauled the dinghy, stripped out the seats and transom and folded it up. 

Over the evening and the morning of the next day, we began stowing everything in spots down below and sealing up every opening that could let rain or bugs enter the boat.  By noon on Wednesday, (after another hour adjusting the lines), we were ready to pull out.  With Sue’s help, we had put her away in record time and were feeling pretty good that she would be fine for the time we would be away.

Picture

The stripped cockpit with openings taped over

Image description
Family Reunion

With our earlier than expected departure, we had only one night on the road and made it back to Hampton on Thursday to Orion.  Our timing was near perfect, since we still had the rental car, allowing us to visit with both of our kids’ families over the weekend.  As another bonus, Dave’s parents and his sister, Diane, would be visiting as well.  After enjoying all of their company for 2 days, it was time to return to Hampton and get Orion straightened up and put her back on the market.  But first, we need to get an engine re-installed. . .